Product Ref: IPJPT20SF
3 people have viewed this product in the last 24 hours
In stock
No rating yet
Thank you. Your review has been submitted and subject to moderation, will appear on this page shortly.
0 loyalty points
We reply in 59 minutes or less within business hours.
Thank you for your interest in Ultrimax Coatings Ltd.
There was a problem with the form submission, please try again.
Jotun Tankguard SF is a two component solvent free amine cured novolac epoxy coating that is a specially designed tank lining with very good chemical resistance. It can be used as a primer, mid coat or finish coat in atmospheric and immersed environments. Suitable for properly prepared carbon steel, galvanised steel, stainless steel and concrete substrates.
Jotun Tankguard SF is designed as an internal lining for offshore, onshore and buried tanks and pipes such as chemical storage, waste water, grey water, process water, concrete bund, fire service lines and drilling mud tanks. Refer to Protective Product Resistance List.
Certificates and approvals may be available on request.
Our Price Promise : Our Jotun Paints 2 Pack Products Pricing includes BOTH Paint and Hardener as a package. Does your competitor offer the same?
Features & Benefits
Wide film thickness range
With the versatility in film thickness you can easily apply in two-coat systems – typically 2 x 200 µm or one-coat systems – like 1 x 300 µm
Application
Tankguard SF is easy to apply with standard airless spray – unlike many other solvent free epoxies. Other benefits are that there is no solvent entrapment and no shrinkage, and it has good pit filling capabilities.
For Use On - Carbon Steel, Galvanised Steel, Stainless Steel, Concrete
Application Method - Brush, Spray
Sheen - Gloss
Colour - Standard / Ready Mixed
VOC Levels - Low (50-149 g/l)
Single, Two or Three Pack - Two-Pack
Pack Size - 15L
Application - Brush, Spray
Coverage - 6.7 - 2 m²/l
Coverage - 2 to 6.7m² per litre
Recommended Thinner/Cleaner - Jotun Thinner No. 17
Solids by Volume - 100%
VOC - 72 g/l
Touch Dry - 6 hours
Touch Dry - 6 hours at 23°C
Recommended Dry Film Thickness - 150 - 500 μm
Recommended Wet Film Thickness - 150 - 500 μm
UN Number (Activator) - UN3066
UN Number (Base) - UN3082
Touch Dry (at 10°C) - 15 hours
Pot Life - 1 hour at 23°C
Published: April 20, 2018
Published: June 23, 2020
Published: June 29, 2020
Published: July 2, 2021
Published: November 9, 2021
Published: February 23, 2023
Published: April 12, 2023
Published: April 19, 2023
The below products are often purchased together with the above item.