Product Ref: IPP203-CAS
7 people have viewed this product in the last 24 hours
Out of stock
No rating yet
Thank you. Your review has been submitted and subject to moderation, will appear on this page shortly.
0 loyalty points
We reply in 59 minutes or less within business hours.
Thank you for your interest in Ultrimax Coatings Ltd.
There was a problem with the form submission, please try again.
A high performance two pack acrylic polyurethane finishing coat which offers an outstanding gloss level and excellent durability. Typical uses include agricultural plant and construction equipment, commercial vehicles and metal structural work.
Ideal for fleet and agricultural sprayers with a full range of popular colours available.
Hardener ** IMPORTANT NOTE
Requires 2K hardener. When spraying 2K paints you must use a hardener with the paint to activate the first coat. Not using a hardener with this product may cause issues after use. You will receive an option to purchase hardener when you add this product to basket. You can choose to add the hardener or 'X' to add to basket without hardener. Ultrimax Coatings ltd takes no responsibility for issues arising with 2K paint used without the proper hardener.
Colours - Any RAL & BS
Pot-life - 4 hours (at higher temperatures pot-life decreases).
Dry film appearance - Glossy
Practical cover rate - 8m²/litre. The cover rate is calculated on the suggested thickness and applied on plane and regular surfaces. NB: Data recorded @ 20°C.(68°F)
RECOMMENDED THICKNESS - 40 - 50 µm dry film, waiting 5 - 10 minutes between coats.
Stir thoroughly to achieve even colour and consistency, then add the suitable:
1 Part Ultrimax Universal Activator
10-20% Ultrimax Universal Thinners
Iron surfaces Take off any trace of rust, iron scale, grease and moisture by sand-blasting SA2.5 grade; otherwise, carry out a careful mechanical cleaning followed by solvent degreasing. Then apply the primer.
Galvanized steel Remove iron scale and foreign matters. Degrease carefully with organic solvents and apply primer.
Aluminium and light alloys: Chromatising or phosphochromatising treatment; otherwise, slight matting with sandpaper followed by organic solvent degreasing. Next, apply primer.
Published: June 29, 2020
Published: November 16, 2020
Published: July 2, 2021
Published: November 9, 2021
Published: February 23, 2023
The below products are often purchased together with the above item.
We strongly recommend that you also purchase the below with this product. Add to basket or cancel top right.
Out of stock
Out of stock