• Aquimax 1 - Ral 2011 Orange

Aquimax 1 - Ral 2011 Orange - 20 Litre - Ultrimax Coatings

Product Ref: IPW020-2011

2 people have viewed this product in the last 24 hours

£0.00 ex. VAT £0.00 inc. VATRRP: £0.00
View Favourites

 In stock 

Out of stock

Product Rating

No rating yet

Write your own review

Write a review

Thank you. Your review has been submitted and subject to moderation, will appear on this page shortly.

0 loyalty points

Ask a Question

We reply in 59 minutes or less within business hours.

Thank you for your interest in Ultrimax Coatings Ltd.

There was a problem with the form submission, please try again.

Product Description

 

Aquimax 1 - Water Based, Primer Finish Coat

Aquimax 1 is a fast drying, water based primer finish that offers a superior anti-corrosive coating. If you’re looking for an industrial primer with great durability, Aquimax 1 is the perfect choice.

Aquimax 1 can easily be applied directly to metal surfaces and has zinc phosphate pigments to protect against rust. This primer can be used for a range of metal applications, including skips and shipping containers.

It’s also recommended for use on decorative steel, sheet metal and many other substrates. To get the most from Aquimax 1, surfaces should be free from oil, dirt, rust, grease and any other contaminates before use.

Where protection against rust is important, Aquimax 1 primer is a great choice. It contains flash rust inhibitor, and is based on high solids styrene acrylic emulsions and zinc phosphate anti-corrosion pigments, making it unbeatable it the battle against rust.

 

Water Based Dry Time

Touch dry in 12 minutes, and hard dry in 24 hours, Aquimax 1 is fast drying and will help to speed up project turnaround times. To further reduce drying times, use ambient airflow across your coated article. After 24 hours, you’re ready to apply your over coat.

Aquimax 1 is available in a wide range of colours. We can colour-match to an existing sample if required, to ensure your primer is perfectly tailored to your requirements. Aquimax 1 comes in either 5 or 20 litre packs.

Technical Detail

RECOMMENDED USE

Suitable for use on decorative and structural steel, sheet metal and many other substrates.

 

PHYSICAL PROPERTIES

Viscocity: Approximately 135 seconds Ford 4 Cup@20°C

Spraying Viscosity: Typically 90 seconds dependent on spray equipment Volume Solids: Typically 50%

Volatile Organic Content: Typically 70 grams/litre Specific Gravity: Typically 1.2

 

FILM THICKNESS & SPREADING RATE

Dry 25-30μ Wet 50 - 70μ

 

SURFACE PREPARATION All substrates to be free from oil, dirt, rust, grease and any other contaminates. Consult our technical staff for information.

Videos

Compare Products (0)

This site uses cookies to provide you with a better on-site experience. By continuing your visit, you accept their use as set out in our Cookie & Privacy Policy. OK