• Colormax Aerosol - Cellimax - Bs. 00a01
  • AEP103-00A01 - 2
  • AEP103-00A01 - 3

Colormax Aerosol - Cellimax - BS. 00A01

Product Ref: AEP103-00A01

2 people have viewed this product in the last 24 hours

Colour

Choose Colour

Current colour: Ash grey / Oyster grey / Portland (BS. 00A01)

£0.00 ex. VAT £0.00 inc. VATRRP: £0.00
View Favourites

 In stock 

Out of stock

Product Rating

No rating yet

Write your own review

Write a review

Thank you. Your review has been submitted and subject to moderation, will appear on this page shortly.

0 loyalty points

Ask a Question

We reply in 59 minutes or less within business hours.

Thank you for your interest in Ultrimax Coatings Ltd.

There was a problem with the form submission, please try again.

  • The CAPTCHA could not be validated. Please try again.

Product Description

Colormax Aerosol Cellimax

Colormax Aerosol Cellimax is a very rapid air drying high gloss coating. It can be polished to remove surface imperfections and is capable of producing an automotive quality of finish. It is used when a glossy, rapid drying, hard wearing finish is required.

  • 400ml Spray can with spray gun style nozzle for ease of spraying on site
  • Dries well at low temperatures - can be applied down to 5°C
  • Excellent gloss and build straight from the gun
  • Excellent re-coating ability
  • Imperfections and film damage can be repaired easily
  • Coating can be readily polished

 

Technical Detail

 

RECOMMENDED USE

Nitrosynthetic enamel is a very rapid air drying high gloss coating which is very easy to apply by spray. It can polished to remove surface imperfections and is capable of producing an automotive quality of finish. It is used a little in these sectors, when a high gloss, rapid drying hard wearing finish is required.

 

PHYSICAL PROPERTIES

Composition Based on nitrocellulose modified with alkyd resin and plasticiser and pigmented with suitably selected pigments

Volume solids: 32% (for black)

Weight solids: 41% (for black)

VOC content: 580 gm/litre

Supply viscosity: 6.0 poise at 20°C

Typical film thickness: 80 microns wet and 25 microns dry

Theoretical coverage: 12.5 sq. metres/litre at 80 microns wet film thickness

Dry heat resistance: 50°C Flash Point: Below 21°C

Compare Products (0)

This site uses cookies to provide you with a better on-site experience. By continuing your visit, you accept their use as set out in our Cookie & Privacy Policy. OK

Chat