Product Ref: IPS103A
2 people have viewed this product in the last 24 hours
Out of stock
No rating yet
Thank you. Your review has been submitted and subject to moderation, will appear on this page shortly.
0 loyalty points
We reply in 59 minutes or less within business hours.
Thank you for your interest in Ultrimax Coatings Ltd.
There was a problem with the form submission, please try again.
This is a one component physically drying silicone acrylic coating. It is an aluminium pigmented product.
Jotun Solvalitt Aluminium is a one component physically drying silicone acrylic coating that is an aluminium pigmented product leaving a metallic silver finish. Suitable for properly prepared carbon steel, galvanised steel, stainless steel and aluminium substrates.
Jotun Solvalitt Alu is designed as a heat resistant coating suitable for insulated and non insulated surfaces.
Dry, atmospheric - Heat resistance = 600 °C
Peak temperature duration max. 1 hour.
The temperatures listed relate to retention of protective properties. Aesthetic properties may suffer at these
Designed as heat resistant coating. Suitable for insulated and non insulated surfaces. Recommended in combination with an inorganic zinc silicate coating as primer, providing heat resistance up to 400 °C and long corrosion protection.
For shorter periods, such a combined system can handle peak temperatures up to 540 °C.
|Solids by volume||ISO 3233||43 ± 2 %|
|Gloss level (GU 60 °)||ISO 2813||matt (0-35)|
|Flash point||ISO 3679 Method 1||26°C|
|VOC-EU||IED (2010/75/EU) (theoretical)||483 g/l|
The provided data is typical for factory produced products, subject to slight variation depending on colour.
Note: Heat resistant topcoats can be tinted in a range of colours. However, due to its pigmentation certain colours will appear less gloss and colour stable than others.
|Typical recommended specification range|
|Dry film thickness||20-30μm|
|Wet film thickness||50-70μm|
|Theoretical spreading rate||21-14m²/l|
To secure lasting adhesion to the subsequent product all surfaces shall be clean, dry and free from any contamination.
|Surface preparation summary table|
|Carbon steel||Sa 2½ (ISO 8501-1)||Sa 2½ (ISO 8501-1)|
|Stainless steel||Cleanliness and surface profile corresponding to Sa 2½ (ISO 8501-1), Fine G (ISO 8503-2)||Cleanliness and surface profile corresponding to Sa 2½ (ISO 8501-1), Fine G (ISO 8503-2)|
|The surface shall be hand or machine abraded with non-metallic abrasives or bonded fibre machine or hand abrasive pads to impa|
Published: June 23, 2020
Published: June 29, 2020
Published: July 2, 2021
Published: November 9, 2021
The below products are often purchased together with the above item.