Time Remaining
Product Ref: PPF013GD
2 people have viewed this product in the last 24 hours
In stock
No rating yet
Thank you. Your review has been submitted and subject to moderation, will appear on this page shortly.
0 loyalty points
We reply in 59 minutes or less within business hours.
Thank you for your interest in Ultrimax Coatings Ltd.
There was a problem with the form submission, please try again.
Contains:
A 2k high build primer with excellent coverage, it is easy to apply and flat giving a good final appearance
Can be applied over original factory primers, previously primed GRP/Fiberglass, steel, polyester putty, well sanded existing finishes in solid condition, after degreasing.
Kapci 625 primer 2K acrylic filler is suitable for air dry, low bake and infra red drying. It’s developed for use under 2K acrylic paints or base costs.
4:1 Mixing ratio
Product Kapci Filler 625
Hardeners Kapci 621
2K Thinners 600F, 600, 601
Mixing ratio 4:1:1
Viscosity, DIN 4/20°C 16-20 s
Pot Life,20°C: 4 hours
Fluid tip Gravity or Suction feed: 1.6-1.8 mm Pressure: 3.0-3.5 bar/ 45-50 psi inlet
Fluid tip Gravity or Suction feed: 1.6-1.8 mm Pressure: refer to manufacturers recommendation, normally 2 bar/30 psi inlet
Apply 2 coats to reach dry film thickness of 60-80 microns.
5-10 minutes between coats depending on film thickness and drying conditions; 20 minutes before baking;
Drying time, Air dry/20°C
3.5-4 hours; Depending on film thickness; Drying time , Force dry/60°C metal temperature 30 min Infra Red drying, short wave 8-12 min after 5 min flash The above features are a guideline only and will depend on film thickness and drying conditions.
