Jotun Penguard Express Metal Primer Paint - Off White
Product Ref: IPTPW05
2 people have viewed this product in the last 24 hours
No rating yet
Write a review
Thank you. Your review has been submitted and subject to moderation, will appear on this page shortly.
0 loyalty points
Ask a Question
We reply in 59 minutes or less within business hours.
Thank you for your interest in Ultrimax Coatings Ltd.
There was a problem with the form submission, please try again.
Jotun Penguard Express Metal Primer Paint - 2 Pack
Jotun Penguard Express Metal Primer Paint is a fast drying, high solids two-pack epoxy coating which may be applied in high film thickness and at lower temperatures.
Anti-Corrosive 2 Pack Primer
An anti corrosive primer and/or intermediate coating for corrosion protection of steel and other substrates in atmospheric exposure where fast dry-to-recoat and/or dry-to-handle times are desired. Can be used alone or in various systems of primers and topcoats.
Penguard Express Product description
This is a two component amine cured epoxy coating. It is a fast drying, high solids, high build product. Specially designed for new construction where fast dry to handle and over coating times are required. Can be used as a metal primer paint, mid coat, finish coat or as single coat system in atmospheric environments.
Suitable for properly prepared carbon steel, aluminium, concrete and galvanised steel substrates. It can be applied at sub zero
Approvals and certificates
Pre-qualification testing in accordance with NORSOK M-501, Rev. 5, System 1, suitable for exterior exposure in offshore environment, below 120 °C.
Tested in accordance with ISO 12944-5, C5-High environment
grey, off white
Other Penguard Undercoat Paints for Steel
Other variants available
Penguard Express MIO
Penguard Express ZP
Penguard Express CF
Suitable for structural steel and piping to be exposed to highly corrosive environments, C5I or C5M (ISO
12944-2). Recommended for offshore environments, refineries, power plants, bridges, buildings and mining
Refer to separate TDS for each variant
Jotun Primer Application methods
The product can be applied by
Spray: Use airless spray.
Brush: Recommended for stripe coating and small areas. Care must be taken to achieve the
specified dry film thickness.
Thinners / Cleaning solvent to use with Metal Primer Paint
Thinner: Jotun Thinner No. 17 -
Undercoat Paint to TopCoat Product compatibility
Depending on the actual exposure of the coating system, various primers and topcoats can be used in combination with this product. Some examples are shown below. Contact Ultrimax for specific system recommendations.
Previous coat: inorganic zinc silicate shop primer, epoxy, epoxy mastic, zinc epoxy, zinc silicate, organic shop primer
Subsequent coat: acrylic, epoxy, polyurethane, polysiloxane
Metal Primer Spraying Guide
Guiding data for airless spray
Nozzle tip (inch/1000):17-23
Pressure at nozzle (minimum): 150 bar/2100 psi
Manufacturer - Jotun
For Use On -Steel, Galvanised Steel, Shop Primed Steel, Concrete
Sheen - Matt
Colour - Standard / Ready Mixed
Single, Two or Three Pack - Two-Pack
Product Certifications - NORSOK M-501, Rev. 5, System 1, ISO 12944-5
Pack Size - 5L
Coverage - 3 to 9.9m²/l
Touch Dry - 1 hour
UN Number (Activator) - UN1263
UN Number (Base) - UN1263