Time Remaining
Time Remaining
Product Ref: IPTPW05
4 people have viewed this product in the last 24 hours
In stock
No rating yet
Thank you. Your review has been submitted and subject to moderation, will appear on this page shortly.
0 loyalty points
We reply in 59 minutes or less within business hours.
Thank you for your interest in HEAD OFFICE - Ultrimax Coatings Ltd.
There was a problem with the form submission, please try again.
Jotun Penguard Express Metal Primer Paint is a fast drying, high solids two-pack epoxy coating which may be applied in high film thickness and at lower temperatures.
Our Price Promise : Our Jotun Paints 2 Pack Products Pricing includes BOTH Paint and Hardener as a package. Does your competitor offer the same?
An anti corrosive primer and/or intermediate coating for corrosion protection of steel and other substrates in atmospheric exposure where fast dry-to-recoat and/or dry-to-handle times are desired. Can be used alone or in various systems of primers and topcoats.
This is a two component amine cured epoxy coating. It is a fast drying, high solids, high build product. Specially designed for new construction where fast dry to handle and over coating times are required. Can be used as a metal primer paint, mid coat, finish coat or as single coat system in atmospheric environments.
Suitable for properly prepared carbon steel, aluminium, concrete and galvanised steel substrates. It can be applied at sub zero surface temperatures.
Pre-qualification testing in accordance with NORSOK M-501, Rev. 5, System 1, suitable for exterior exposure in offshore environment, below 120 °C.
Tested in accordance with ISO 12944-5, C5-High environment
grey, off white
Other variants available
Penguard Express MIO
Penguard Express ZP
Penguard Express CF
Suitable for structural steel and piping to be exposed to highly corrosive environments, C5I or C5M (ISO
12944-2). Recommended for offshore environments, refineries, power plants, bridges, buildings and mining
equipment.
Refer to separate TDS for each variant
The product can be applied by
Spray: Use airless spray.
Brush: Recommended for stripe coating and small areas. Care must be taken to achieve the
specified dry film thickness.
Thinner: Jotun Thinner No. 17 -
Depending on the actual exposure of the coating system, various primers and topcoats can be used in combination with this product. Some examples are shown below. Contact Ultrimax for specific system recommendations.
Previous coat: inorganic zinc silicate shop primer, epoxy, epoxy mastic, zinc epoxy, zinc silicate, organic shop primer
Subsequent coat: acrylic, epoxy, polyurethane, polysiloxane
Guiding data for airless spray
Nozzle tip (inch/1000):17-23
Pressure at nozzle (minimum): 150 bar/2100 psi
Manufacturer - Jotun
For Use On -Steel, Galvanised Steel, Shop Primed Steel, Concrete
Sheen - Matt
Colour - Standard / Ready Mixed
Single, Two or Three Pack - Two-Pack
Product Certifications - NORSOK M-501, Rev. 5, System 1, ISO 12944-5
Pack Size - 5L
Coverage - 3 to 9.9m²/l
Touch Dry - 1 hour
UN Number (Activator) - UN1263
UN Number (Base) - UN1263
Published: April 20, 2018
Published: June 23, 2020
Published: June 29, 2020
Published: July 2, 2021
Published: November 9, 2021
Published: February 23, 2023
Published: April 12, 2023
Published: April 19, 2023
Published: July 27, 2023