Jotun Pilot 2 1K Paint - BS. 00A01

7 people have viewed this product in the last 24 hours

£43.00 ex. VAT £51.60 inc. VATRRP: £0.00

In stockdelivered within 2-3 days

Product Rating

No rating yet

Write your own review

Write a review

Thank you. Your review has been submitted and subject to moderation, will appear on this page shortly.

0 loyalty points

Product Description

 

Jotun Pilot 2 1K Paint

Jotun Pilot II is a one component oxidatively drying alkyd coating that has a gloss finish with good gloss retention. To be used as topcoat in atmospheric environments.

Jotun Pilot II is recommended as a topcoat, and for touch-up purposes for marine engines, topside, deck and superstructure areas and for a wide range of industrial structures.

Approvals and certificates

  • Low flame spread certificate acording to IMO/Solas directive
  • Grain, Newcastle Ocupational Health
  • Food, Compliant with USA, FDA Title 21, Part 175.300 for dry solids

Additional certificates and approvals may be available on request.

Features & Benefits

  • Reduces application cost
  • No special painting skills required
  • Nice finish

Reduces your application costs
Requires no mixing and has no pot life restrictions, which reduce time spent on preparation, waste, spillage and leftovers
No special painting skills required

Surface tolerant
Surface tolerant and excellent application properties regardless of which equipment you use
Can be applied to any surface of new or aged coatings in atmospheric conditions

Aesthetical appearance
Provides a high gloss finish that makes your coated surface look smooth, clean and appealing

Primers
Together with primers like Alkydprimer or Pilot QD Primer, Pilot II will form a low to medium corrosion protection system, respectively, as defined by ISO 12944.

 

1K Alkyd Paint by Jotun

Penguard Topcoat bases are intermediates and need to be processed before use.
As finishing coat in epoxy systems. Also on concrete where epoxy paints are specified.

 

Recommended Finishing Coat for Marine & Boat

Typical use:

Recommended for topside, deck and superstructure.

Protective:
Suitable for a wide range of industrial structures.

 

Approvals and certificates

    • Low flame spread certificate acording to IMO/Solas directive
    • Grain, Newcastle Ocupational Health
    • Food, Compliant with USA, FDA Title 21, Part 175.300 for dry solids

 

Colours

Use the colour picker for any RAL or BS chart offering

Jotun Finishing Coat Drying

Drying and curing times are determined under controlled temperatures and relative humidity below 85%, and within the DFT range of the product.

Walk-on-dry: Minimum time before the coating can tolerate normal foot traffic without permanent marks, imprints or other physical damage.

Dried to over coat, minimum: The shortest time allowed before the next coat can be applied.

Surface (touch) dry: The state of drying when slight pressure with a finger does

Technical Detail

 

Application methods

The product can be applied by

Spray: Use air spray or airless spray.

Brush: Recommended for stripe coating and small areas. Care must be taken to achieve the specified dry film thickness.

Roller: May be used. Care must be taken to achieve the specified dry film thickness

 

Film thickness per coat

Typical recommended specification range

Dry film thickness - 30-50μm

Wet film thickness - 60-105μm

Theoretical spreading rate - 16-9.6 m²/l

Compare Products (0)
Chat