Jotun Paints Penguard Topcoat- Ral 1007

Product Ref: IPT105-1007

5 people have viewed this product in the last 24 hours

In stock

Out of stock

Product Rating

No rating yet

Write your own review

Write a review

Thank you. Your review has been submitted and subject to moderation, will appear on this page shortly.

0 loyalty points

Ask a Question

We reply in 59 minutes or less within business hours.

Thank you for your interest in Ultrimax Coatings Ltd.

There was a problem with the form submission, please try again.

Product Description

Jotun Penguard Topcoat 2K Paint

Jotun Penguard Topcoat is a two-pack epoxy polyamide cured topcoat based on a polyamide cured epoxy resin. This product is a part of a complete system which is certified not to spread surface flames.

Price Promise On Jotun Paints 2 Pack

Our Price Promise : Our Jotun Paints 2 Pack Products Pricing includes BOTH Paint and Hardener as a package. Does your competitor offer the same?

Epoxy Paint by Jotun

Penguard Topcoat bases are intermediates and need to be processed before use. As finishing coat in epoxy systems. Also on concrete where epoxy paints are specified.

Recommended Finishing Coat

Typical use:

Recommended for topside, deck and superstructure.

Protective:
Suitable for a wide range of industrial structures.

Approvals and certificates

Low flame spread certificate acording to IMO/Solas directive
Food, Compliant with USA, FDA Title 21, Part 175.300 for dry solids

Colours

Use the colour picker for any RAL or BS chart offering

Other Penguard Paints:

Other variants available
Penguard Express MIO
Penguard Express ZP
Penguard Express CF
Suitable for structural steel and piping to be exposed to highly corrosive environments, C5I or C5M (ISO
12944-2). Recommended for offshore environments, refineries, power plants, bridges, buildings and mining
equipment.
Refer to separate TDS for each variant

Jotun Paint - Finishing Coat Application methods

The product can be applied by
Spray: Use airless spray.

Brush: Recommended for stripe coating and small areas. Care must be taken to achieve the
specified dry film thickness.

Roller: May be used. Care must be taken to achieve the specified dry film thickness.

Thinners / Cleaning solvent to use with Metal Primer Paint

Thinner: Jotun Thinner No. 17

Jotun Finishing Coat Drying

Drying and curing times are determined under controlled temperatures and relative humidity below 85%, and within the DFT range of the product.

Walk-on-dry: Minimum time before the coating can tolerate normal foot traffic without permanent marks, imprints or other physical damage.

Dried to over coat, minimum: The shortest time allowed before the next coat can be applied.

Surface (touch) dry: The state of drying when slight pressure with a finger does not leave an imprint or reveal tackiness. Dry sand sprinkled on the surface can be brushed off without sticking to or causing damage to the surface.

Dried/cured for service: Minimum time before the coating can be permanently exposed to the intended environment/medium.