Time Remaining For Same Day Dispatch -
Time Remaining For Same Day Dispatch -
Product Ref: IPT005-1002
6 people have viewed this product in the last 24 hours
In stock
No rating yet
Thank you. Your review has been submitted and subject to moderation, will appear on this page shortly.
0 loyalty points
Jotun Penguard Topcoat is a two-pack epoxy polyamide cured topcoat based on a polyamide cured epoxy resin. This product is a part of a complete system which is certified not to spread surface flames.
Our Price Promise : Our Jotun Paints 2 Pack Products Pricing includes BOTH Paint and Hardener as a package. Does your competitor offer the same?
Penguard Topcoat bases are intermediates and need to be processed before use. As finishing coat in epoxy systems. Also on concrete where epoxy paints are specified.
Typical use:
Recommended for topside, deck and superstructure.
Protective:
Suitable for a wide range of industrial structures.
Use the colour picker for any RAL or BS chart offering
Other variants available
Penguard Express MIO
Penguard Express ZP
Penguard Express CF
Suitable for structural steel and piping to be exposed to highly corrosive environments, C5I or C5M (ISO
12944-2). Recommended for offshore environments, refineries, power plants, bridges, buildings and mining
equipment.
Refer to separate TDS for each variant
The product can be applied by
Spray: Use airless spray.
Brush: Recommended for stripe coating and small areas. Care must be taken to achieve the
specified dry film thickness.
Roller: May be used. Care must be taken to achieve the specified dry film thickness.
Thinner: Jotun Thinner No. 17
Drying and curing times are determined under controlled temperatures and relative humidity below 85%, and within the DFT range of the product.
Walk-on-dry: Minimum time before the coating can tolerate normal foot traffic without permanent marks, imprints or other physical damage.
Dried to over coat, minimum: The shortest time allowed before the next coat can be applied.
Surface (touch) dry: The state of drying when slight pressure with a finger does not leave an imprint or reveal tackiness. Dry sand sprinkled on the surface can be brushed off without sticking to or causing damage to the surface.
Dried/cured for service: Minimum time before the coating can be permanently exposed to the intended environment/medium.
Guiding data for airless spray
Nozzle tip (inch/1000):15-19
Application Method - Brush, Roller, Spray
Sheen - Matt
Colour - Fully Tintable
Single, Two or Three Pack - Two-Pack
Pack Size - 5L, 20L
Application - Brush, Roller, Spray
Coverage - 8.3 to 12.5m² per litre
Touch Dry - 1.5 hours
Published: April 20, 2018
Published: June 23, 2020
Published: June 29, 2020
Published: September 11, 2020
Published: July 2, 2021
Published: November 9, 2021
Published: April 12, 2023
Published: April 19, 2023
Published: July 27, 2023
Published: October 24, 2023
The below products are often purchased together with the above item.
