Time Remaining

High Density Foam Roller Refill 100mm - 4inch (pkt 10)

High Density Foam Roller Refill (Pkt 10)

Product Ref: BRS014

6 people have viewed this product in the last 24 hours

4"
£0.00 ex. VAT £0.00 inc. VATRRP: £0.00
View Favourites

 In stock 

Out of stock

Product Rating

No rating yet

Write your own review

Write a review

Thank you. Your review has been submitted and subject to moderation, will appear on this page shortly.

0 loyalty points

Ask a Question

We reply in 59 minutes or less within business hours.

Thank you for your interest in Ultrimax Coatings Ltd.

There was a problem with the form submission, please try again.

  • The CAPTCHA could not be validated. Please try again.

Product Description

Exceptional dense foam quality for serious finishing jobs on smooth surfaces.  Achieves a smooth bubble-free finish.  For use with solvent-borne gloss, primers, lacquers, acrylic and synthetic resin varnishes, water-borne acrylic paints and liquid adhesives with low-solvent contents. Appropriate for the smallest, most difficult to reach areas with full corner coverage.  Push on/Pull off design for use with standard 4” frames.  Inner core extends to approximately 1 cm of opposite end, ensuring that the dense foam outer is fully supported during use.  Available in 11cm (4 inch), which is rounded on the frame side.  

Blog Posts

Compare Products (0)

This site uses cookies to provide you with a better on-site experience. By continuing your visit, you accept their use as set out in our Cookie & Privacy Policy. OK

Chat